Chair leg pin glide with a rubber buffer that sits between the wooden chair leg and chrome-plated steel base. The rubber insert provides added seating comfort and a 'softer' seat when seated for long periods of time. The foot pad diameter is 24mm, and the height is 10mm. The rubber insert provides added seating comfort and a 'softer' seat when seated for long periods of time.
- 24mm diameter
- 10mm height
- 20mm nail length
- 2.5mm nail shank diamter
- Chrome-plated steel base
- Black rubber buffer
Most timbers used in chair legs are hard grain timbers and it is advisable to drill a slightly undersized (or no larger than the actual shank diameter) pilot hole in the centre of each chair leg during fitting to avoid splitting of the timber. The pilot hole can be 15mm deep so that the tip of the nail digs slightly into the timber to retain the glide in place without it falling out when being moved. The shank diameter is 2.50mm, so a fractionally undersized pilot hole will also hold the glide in place when the screw thread bites into it. In addition two sides of the nail are grooved to aid in holding them in place.
|